#1
|
|||
|
|||
Power questions
I'm down to the final step, but I want to check my assumptions before I wire up the power supplies.
I'm planning to connect the black wire from the power cord to one of the "AC SW" terminals on the D/C board. Then I'll run a red wire from the other "AC SW" terminal to the L terminal on one power supply and then further on to the L terminal on the other power supply. I'll connect the white wire from the power coard to the N terminal on one power supply and then further on to the N terminal on the other power supply. Is this correct? Next questions: The large power supply V+ terminal is +8vDC The small power supply V+ terminal is +16vDC The small power supply V- terminal is -16vDC PAge 72 of the MITS manual says pins 1/51 are +5V, pin 2 is +15V, and pin 52 is -15V. I assume we are to use +8V, +16V, and -16V, correct? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
High Voltage Power Supply Links | Grant Stockly | Electronics | 0 | 12-15-2008 10:58 PM |
Power Supply Upgrade | Charles | Troubleshooting | 3 | 09-30-2008 07:54 PM |
Updated power supply and the RTC card | sje | Altair 8800 | 7 | 11-10-2007 03:44 PM |
AltairKit.com is online! | Grant Stockly | Announcements | 10 | 11-28-2006 10:20 PM |